rifle barrel

  1. JmacD

    Rather long Long gun case needed.

    I’ve been working on a semi precision longer range hunting rifle. I am haven’t trouble finding a hard case that it will fit in. I found a very cheap one it barely fit in, but since I upgraded the scope and stock, it’s now a no-go. It currently measures 48.5” butt-muzzle. Wondering about the...
  2. JmacD

    250-3000 Twist rate

    I'm shooting a 250-3000/savage built on a Mauser action (96 I believe) . It currently has about a 1:12 twist barrel. It doesn’t stabilize anything over 100gr very well. I’m planning on rebuilding the rifle for my daughter to hunt with (shorter stock, safety lever conversion, trigger etc) and I’m...
    • JmacD
    • Thread
    • 250 savage 250-3000 question rifle rifle barrel rifle bolt twist and stabilization twist rate
    • Replies: 7
    • Forum: Rifle Country
  3. V

    Customer Supplied Barstock for Barrel

    I'm a new member and this will be my first bolt rifle build. Bought a 30"x1.265" round bar of annealed M48 tool steel. It's 33hrc now and machinable. The surface should work harden to 60+hrc as it's shot and last forever. I currently have a Weatherby Vanguard LA receiver that I want to put it...
    • Vendetta
    • Thread
    • barrel barrel brand custom rifle barrel rifling
    • Replies: 26
    • Forum: Rifle Country
  4. T

    Rifle Bore Pitting

    I have acquired a 1967 Remington 760 game master it is a 270. The end of the barrel was filled with dry dirt the first 4 inches of the barrel. After cleaning the bore It is beautiful except the last 3 inches has pitting where the dirt was(for years) it doesn’t appear that deep but quite a bit...
  5. IronsightJM

    Ruger 10/22 in NY?

    Hey all, so last week I ordered a Ruger 10/22 and the FFL I sent it to had to ship it back Becuase a part of it wasn’t legal here in NY. The stupid thing about all of this is they didn’t even include it in the description of it. What was illegal is that it came with a threaded barrel. Obviously...
    • IronsightJM
    • Thread
    • barrel legal new york ny state rifle rifle barrel threaded threaded barrel
    • Replies: 36
    • Forum: Rifle Country
  6. I

    Twist rate on a 16 inch PTR 91 SC model?

    I just got a PTR 91 squad carbine model with the 16 inch fluted bull barrel and I'm not sure the twist rate on it. None of that information came with the gun as far as I know. I tried looking it up. I believe the 18 inch barrels have a 1 in 12 twist and the 16 inch barrels have a 1 in 10 twist...
  7. Sidewinder243

    Model 100 barrel

    Hey everyone, I've got a Winchester model 100 in .243 that I'm cleaning, and I looked down the barrel and there appeared to be a dark ring near the rear sight. I would take a picture but you know it's impossible to photograph the inside of a barrel. Could there be a... ring... in the barrel? Or...
Back
Top