Captains1911
Member
I just installed a 10/22 auto bolt release (Volquartsen - Silver). After installing and inspecting it with the trigger housing separate from the rifle, and operating both the magazine release button and bolt release, I noticed that the magazine latch plunger (Part B-36) sometimes tends the to get stuck on the edge of the bolt release plate, binding up both controls. It almost seems like the plate of the bolt release needs to extend a little further forward to allow the chamfered edge of the magazine plunger to ride along the side of it rather than catching the front edge of it. This is a brand new rifle so perhaps it just needs to break in a little, or perhaps it will function fine once everything is assembled, but I was just curious if this was common or not. My other 10/22 with the factory bolt release doesn't do this.