10mm Wilson shell holder

Status
Not open for further replies.
T

TimT

Member
Joined
Dec 14, 2006
Messages
83
Location
foothills of the Brooks Range
Hello, been wondering why Wilson would make a shell holder that needs an additional boost to reach the cutter. My 10mm brass is now backed by a gaudy looking bolt with a nut to reach the cutter. It does work but does Wilson offer something to assist in trimming the brass? Is this normal or am I missing something?
 
I've loaded thousands of rounds of 10mm, and never found the need to trim any of them. Are you sure yours need trimming?

Hope this helps.

Fred
 
Fred, it does help - thanks. I measured my Starline brass and most are either .987 or 88". Did not know from any experience how often brass in my 10 could be reloaded and/or trimmed when needed.

I buy Wilson for a good trim with my calibers and it is a first for any handgun of mine and to see the Micrometer not being able to reach the case was peculiar.

regards,
Tim
 
My experience is the same as Fred's--e.g., I've loaded thousands of 10 mm, and never had to trim. FWIW, I use Starline almost exclusively.

Jim H.
 
Status
Not open for further replies.
Back
Top