GaryK
Member
You guys have been a lot of help in getting my 1911 sorted out. I am the guy that had the Norinco with the long barrel link. I replaced it with the Wilson #3 link and oversized pin, per your suggestions. and it works fine now. I have another problem. This gun has MMC sights installed. The rear sight was installed correctly but the front one is screwed up. What they did was cut a flat on top of the slide before cutting the dovetail. This caused the front sight to be too low. I thought about buying a higher sight but the existing sight is a night site and the workmanship on the dovetail is poor. What can be done to correct this? Can the slide be welded and a new dovetail be cut? If so then who would you recommend to do this? Does anyone have any other ideas on how to fix this? Thanks.