Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

2 revolver questions

Discussion in 'Handguns: Revolvers' started by coosbaycreep, Mar 6, 2010.

Thread Status:
Not open for further replies.
  1. coosbaycreep

    coosbaycreep Member

    Joined:
    Nov 8, 2007
    Messages:
    435
    Location:
    near Roseburg, Oregon
    The screw on the cylinder release button on my 629 has come loose twice now, and the same thing happens to my 29 as well. Is there a certain type of locktite or something I can put on the screw that will keep it tight, but not be so tight that I won't be able to remove it ever again?

    Also, my 629 feels like it drags or something sometimes when you pull the hammer back. It only does it on one or two chambers I think, but there's definitely times when it requires more effort to cock the trigger. Any ideas on what could be wrong with it?

    I bought this gun new too, and haven't put a whole lot of rounds through it yet, and no hot loads either.
     
  2. bikerdoc

    bikerdoc Moderator Staff Member

    Joined:
    Jan 8, 2008
    Messages:
    16,592
    Location:
    Southern Virginia
    You might want to move this to the gunsmithing and repair sub forum
     
  3. The Bushmaster

    The Bushmaster Member

    Joined:
    Jan 29, 2005
    Messages:
    7,849
    Location:
    Ava, Missouri
    Loctite 222. "A little dab will do ya"...On the threads.
     
  4. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
Thread Status:
Not open for further replies.

Share This Page