As intro, I've reloaded handgun for years and rifle for a couple years but this is a new problem.
I have a few hundred once fired S&B cases. I'm using a Lee full length resizing die and a Lee zip trim as well as a Lee cutter and case length guide.
Some of the brass is too tight at the mouth, after resizing, for the shoulder of the case length guide. It is all S&B and probably fired from two different carbines.
Any ideas as to cause and any solutions. I've not encountered this before.
Thanks,
Jess
I have a few hundred once fired S&B cases. I'm using a Lee full length resizing die and a Lee zip trim as well as a Lee cutter and case length guide.
Some of the brass is too tight at the mouth, after resizing, for the shoulder of the case length guide. It is all S&B and probably fired from two different carbines.
Any ideas as to cause and any solutions. I've not encountered this before.
Thanks,
Jess