A friend of mine gave me some 308 cases as he sold his rifle-all once fired out of a 700P. I full length resized them and trimmed to length, but I noticed a little wobble in the case neck as I was running them through my zip-trim. My RCBS case master showed a .005" runout on most of the cases
I was using my Lee full length resizer, set up as per instructions.
Just to see what would happen, I ran a few cases through my RCBS die and the runout at the case neck dropped to <.001"
What effect, if any, am I likely to see with the cases resized on the Lee die?
Never had used it before-but I do like the Lee collet neck sizing die a lot.
I was using my Lee full length resizer, set up as per instructions.
Just to see what would happen, I ran a few cases through my RCBS die and the runout at the case neck dropped to <.001"
What effect, if any, am I likely to see with the cases resized on the Lee die?
Never had used it before-but I do like the Lee collet neck sizing die a lot.