308 Brass Made Into 6.5 Creedmoore

[roc1]

Anyone made 308 brass into 6.5 Creedmoore? I read you neck size 308 brass then trim to 1.910 Creedmoore length size in Creedmoore die with expander out the resize with it in? I tried near impossible to resize again with expander in? Anyone tried this? I have Creedmoore brass just have lots 308 thought it might be something worth doing
Thanks
Roc1

 

[joustin]

308 commercial or military brass? The military brass is strong stuff.

 

[roc1]

Lapua brass

 

[7.62 Nato]

I'm not familiar with it but if you can make it with .308, you can probably make it with .243 also. I would think it's easier to neck up .5 mm than neck down 1.12 mm.

 

[roc1]

I got some made will have to turn necks see how they turn out. What I have been told 243 crushes shoulder pretty bad. I ran these thru 243 die to make it easier to do after resizing without expander in the 6.5 die. See what happens pretty big pain wouldn't want to do very many for sure.
Roc1