JLDickmon
Member
OK.. I've been reloading too long to not know I'm missing something, and I'm missing something stoopid..
loading .32 H&R..
new Starline brass..
had sized and was belling mouths..
about 25 rounds in, I noticed they were drawing hard off the expander ball..
about 5 more, one stuck to the ball and I ripped the rim off the case
RCBS carbide dies, Lee shellholder..
I took the die apart, had to take a cookie grinder and thin out a case to where I could crack it and remove it..
polished the ball with the cookie..
about five rounds later, I did it AGAIN..
this time, I took some 220 sand paper and gave the ball a good polish..
five or so rounds later, noticed the cases were drawing back hard..
WTH am I missing?
loading .32 H&R..
new Starline brass..
had sized and was belling mouths..
about 25 rounds in, I noticed they were drawing hard off the expander ball..
about 5 more, one stuck to the ball and I ripped the rim off the case
RCBS carbide dies, Lee shellholder..
I took the die apart, had to take a cookie grinder and thin out a case to where I could crack it and remove it..
polished the ball with the cookie..
about five rounds later, I did it AGAIN..
this time, I took some 220 sand paper and gave the ball a good polish..
five or so rounds later, noticed the cases were drawing back hard..
WTH am I missing?