JCSC
Member
Looking to see if anyone had experience with a Varget load for 175 sierras. I am looking to make some loads for shooting steel with a M48 Hugo.
Normally I have the luxury of starting way low and working up, but I am just looking for a middle of the road target load.
I have seen anywhere up to 53 grains, but was planning around 49?
Any first hand experience out there?
Normally I have the luxury of starting way low and working up, but I am just looking for a middle of the road target load.
I have seen anywhere up to 53 grains, but was planning around 49?
Any first hand experience out there?
Last edited: