shovel66
Member
Hi,
I'm reloading .357 Sig with Dillon dies on a 550B. Have a good load and most chamber and shoot well. However about one out of ten loaded cases do not chamber fully causing the slide not to go into battery. The problem is that the sizing die does not seem to "full length resize" the case and it is just a tad bit too fat just above the head.
I've also tried "outside" resizing all the cases with a .40S&W Dillon die before resizing and loading with the .357 dies. Of course this die is also Dillon.
Can anyone recommend a different resize die that would get the outside of the case a little smaller and fit in the chamber?
The gun is a Glock 27 with a Storm Lake barrel. All factory and Georgia Arms reloads chamber and shoot 100%.
Thanks,
Shovel
I'm reloading .357 Sig with Dillon dies on a 550B. Have a good load and most chamber and shoot well. However about one out of ten loaded cases do not chamber fully causing the slide not to go into battery. The problem is that the sizing die does not seem to "full length resize" the case and it is just a tad bit too fat just above the head.
I've also tried "outside" resizing all the cases with a .40S&W Dillon die before resizing and loading with the .357 dies. Of course this die is also Dillon.
Can anyone recommend a different resize die that would get the outside of the case a little smaller and fit in the chamber?
The gun is a Glock 27 with a Storm Lake barrel. All factory and Georgia Arms reloads chamber and shoot 100%.
Thanks,
Shovel