I bought a bunch of "once-fired" mixed .40s&w brass.
The Remington brass won't hold a bullet. Light pressure will set back the bullet.
I see this isn't a new issue. Problems have been reported before with thin R-P brass having no neck tension.
I am using RCBS dies. I was just wondering if one of the other manufacturers makes their resizing die a few thousandths smaller, to minimum spec or something.
There's not enough R-P brass in the lot to make a custom die feasible, but if anyone is having good luck with reloading R-P brass, whose resizing die are you using?
The Remington brass won't hold a bullet. Light pressure will set back the bullet.
I see this isn't a new issue. Problems have been reported before with thin R-P brass having no neck tension.
I am using RCBS dies. I was just wondering if one of the other manufacturers makes their resizing die a few thousandths smaller, to minimum spec or something.
There's not enough R-P brass in the lot to make a custom die feasible, but if anyone is having good luck with reloading R-P brass, whose resizing die are you using?