345 DeSoto
Member
This might not be the place for this, but has anyone made a Wildcat round out of a .45 ACP bullet and a 30-06 case? I know that to do this with a .308 case takes a BUNCH of fiddleing around...due to the inside diameter (taper) of the .308 case. I'm not talking about cutting down the case to .45 ACP case length...I'm talking about cutting the shoulder and any of the case necessary untill the inside diameter will allow seating of the bullet and allow sufficient outside diameter to headspace on the case. I'm thinking of adding a bit more punch to the .45 (.452) bullet.
If this is inappropriate here, remove it or put it where it should go...
If this is inappropriate here, remove it or put it where it should go...