Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

686-1 cylinder wont rotate...?

Discussion in 'Handguns: Revolvers' started by FreddyKruger, Nov 5, 2011.

Thread Status:
Not open for further replies.
  1. FreddyKruger

    FreddyKruger Member

    Joined:
    Jun 28, 2011
    Messages:
    214
    Location:
    Australia
    I opened her up and gave her a good clean. all i did was remove the side plate. and now the cylinder wont rotate? its not binding or anything, its just like the rotating hand isnt doing anything.

    I looks like the side plate has a guide for it, but buggered if i can figure out whats going on... and here i was hoping to go to the range today :banghead:
     
  2. CSA 357

    CSA 357 Member

    Joined:
    Apr 16, 2006
    Messages:
    1,400
    Location:
    North Alabama
    take the side plate back off, i bet it is the safty bar is not in corectly, try that and let us know you can take it out and put it back together just to see if it will work
     
  3. FreddyKruger

    FreddyKruger Member

    Joined:
    Jun 28, 2011
    Messages:
    214
    Location:
    Australia
    i think ive got it. theres a spring inside the trigger...
     
  4. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Yes there is!

    rc
     
Thread Status:
Not open for further replies.

Share This Page