Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

.90" light mount?

Discussion in 'Rifle Country' started by skarpenz, Mar 28, 2009.

Thread Status:
Not open for further replies.
  1. skarpenz

    skarpenz Member

    Joined:
    Jul 22, 2007
    Messages:
    103
    I have a nice little LED flashlight that measures .90" in diameter and I was wondering if I could just use a regular 1" light mount for this? I have a seen a few mounts that specify a .90" option but they cost almost $60 for the specific ones. I'll tape my light to my gun before I pay $60 for a single ring mount. I tried searching, but I cannot get it to search that specific size. So sorry if this is a frequent question around these parts. :D Thanks guys.

    Tom
     
  2. atblis

    atblis Member

    Joined:
    Feb 19, 2005
    Messages:
    4,531
    Location:
    Neither here nor there
    Probably. You could probably use a piece of rubber to shim it up.
     
  3. skarpenz

    skarpenz Member

    Joined:
    Jul 22, 2007
    Messages:
    103
    I had considered that and if the one I end up ordering doesn't fit I will do that. I didn't know if most people just ROUNDED UP, haha.
     
  4. kirklandkie

    kirklandkie Member

    Joined:
    Mar 3, 2009
    Messages:
    213
    Location:
    Connecticut
    the rubber would also add a level of protection of the "bulb" in your LED flashlight. I know you shouldn't use a regular flashlight on a weapon because it'll blow out the bulb when shooting but i doubt this is applicable for an LED
    just buy the 1" and get some rubber

    -kirk
     
  5. skarpenz

    skarpenz Member

    Joined:
    Jul 22, 2007
    Messages:
    103
    Cool, I'm glad we all think alike on the idea. Thanks guys.
     
Thread Status:
Not open for further replies.

Share This Page