myFRAGisFUBAR
Member
Greetings everyone. I could use a little help with some data. Hodgdon recently changed their site and I am still getting used to it. I just started casting and I have two molds. One is a 120gr 356 TC mold. They cast to about 125 grain. The other mold is a 124 grain round nose 356 mold. They cast to around 128 grains.
The TC mold I have had a little longer and had data at 5.0-5.7 grains of longshot. My OAL is 1.040.
I need a little help with the round nose. I can make the OAL much longer with the round nose. A dummy rounds chambered at much longer than the TC. I want to keep the powder for this load longshot as well. Am I good to stay in the same powder loads with this cast as the TC? Will me comparing it to the BERB RN be acceptable?
http://www.hodgdonreloading.com/data/pistol
Thanks again for all of the help!
The TC mold I have had a little longer and had data at 5.0-5.7 grains of longshot. My OAL is 1.040.
I need a little help with the round nose. I can make the OAL much longer with the round nose. A dummy rounds chambered at much longer than the TC. I want to keep the powder for this load longshot as well. Am I good to stay in the same powder loads with this cast as the TC? Will me comparing it to the BERB RN be acceptable?
http://www.hodgdonreloading.com/data/pistol
Thanks again for all of the help!