pcgunner
Member
I'm reloading for the long haul with what I have in stock after my hiatus - it's a long job again LOL
However, in doing so I have to load the first few hundred for fine tuning in my guns again as well as the new guns we have.
So for example, I have reloaded some 9mm for 2 guns we have to fine tune for accuracy. The Overall length I have my die set to is 1.160 (max is 1.169).
I tend to leave the length alone once I have it set up and I never vary the crimped width once I get it set below the max.
So I was wondering if aside from the powder measure difference do you all take the time to adjust the overall length as well?
Thoughts?
Thanks as always in advance
However, in doing so I have to load the first few hundred for fine tuning in my guns again as well as the new guns we have.
So for example, I have reloaded some 9mm for 2 guns we have to fine tune for accuracy. The Overall length I have my die set to is 1.160 (max is 1.169).
I tend to leave the length alone once I have it set up and I never vary the crimped width once I get it set below the max.
So I was wondering if aside from the powder measure difference do you all take the time to adjust the overall length as well?
Thoughts?
Thanks as always in advance
Last edited: