Any advice on sizing .308 Winchester brass to be used in a 7mm-08 rifle?

[MCMXI]

My Redding FLRS type-S busing die does not size all the way to the shoulder in 243win. There is that tiny area when the body die part and the bushing does not touch the brass.

I can see how that "tiny area" would be larger for a .308/.243 reduction as compared to a .308/.284 reduction. Either way, I was just wondering if I really need to buy a whole new set of dies ... looks like I should.

Thanks.

 

[interlock]

7mm08

1858,
just run them through your full length die. any with a donut or visible deformity run through again, if still no good - discard. will be cheaper than buying a load of new hardware

the sst looks like a good sheep bullet.

please let us know how it goes.

interlock