So I successfully reloaded my first couple of cartridges. I did a couple different amounts of powder and shot 3 shots each. I set the bullet seating die to a result to come out the same as the factory rounds measured. I didn't have much of a an issue.
I found a load that is shooting around .45" groups at 100 yards. To me this is just amazing as it's the best group I've gotten. .8" or so is about normal. One of the other loads shot around this and one shot about 1.5".
So I thought great, I will just load up a few more of this same load. That's when the problem started. I went to set up the seating die again and for some reason I couldn't get it to seat the bullets to the same depth as I had before. I tried several different times to get it set. I finally got a few rounds loaded but I was having to seat them. It would often be a few thousands too tall so I'd then adjust the die and run it through again.
I finally got it to where I thought it was adjusting to the right depth. That was until I tried the next one which seated way too deep. I just can not get it set to seat the bullets the same depth as the load I had before. The last time I don't remember this trouble. I set it which didn't take long then all of them came out the same. This time I can't get it exact and then it seems like none of them are coming out the same.
Are there any tips to do this? It's really being a pain to try to get set.
I found a load that is shooting around .45" groups at 100 yards. To me this is just amazing as it's the best group I've gotten. .8" or so is about normal. One of the other loads shot around this and one shot about 1.5".
So I thought great, I will just load up a few more of this same load. That's when the problem started. I went to set up the seating die again and for some reason I couldn't get it to seat the bullets to the same depth as I had before. I tried several different times to get it set. I finally got a few rounds loaded but I was having to seat them. It would often be a few thousands too tall so I'd then adjust the die and run it through again.
I finally got it to where I thought it was adjusting to the right depth. That was until I tried the next one which seated way too deep. I just can not get it set to seat the bullets the same depth as the load I had before. The last time I don't remember this trouble. I set it which didn't take long then all of them came out the same. This time I can't get it exact and then it seems like none of them are coming out the same.
Are there any tips to do this? It's really being a pain to try to get set.