You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Barrel for S & W M & P 1905 38 Spl
- Thread starter ucs100
- Start date
- Status
-
Not open for further replies.
I would try www.gunpartscorp.com:
Finding a barrel shouldn't be difficult, but a 5"/nickel finish might be. They show "sold out," but sometimes an e-mail will turn up something that isn't cataloged on the 'net.
Finding a barrel shouldn't be difficult, but a 5"/nickel finish might be. They show "sold out," but sometimes an e-mail will turn up something that isn't cataloged on the 'net.
Check on gunbroker. There is always new stuff being listed. I also see a lot of parts kits from guns that some police dept chopped up.
Check under "parts-pistols-barrels" and "parts kits" in the categories, but also note that many people list stuff in wrong categories for whatever reason. You may end up buying a whole bag of parts.
K frames had a lot of minor changes over the years. I bought a barrel off gunbroker for a hand ejector (pre model 10 K frame) and I need to set it back at least one turn then reset the gap. The shank portion forward of the threads is already thin so it's going to look a little "off".
Check under "parts-pistols-barrels" and "parts kits" in the categories, but also note that many people list stuff in wrong categories for whatever reason. You may end up buying a whole bag of parts.
K frames had a lot of minor changes over the years. I bought a barrel off gunbroker for a hand ejector (pre model 10 K frame) and I need to set it back at least one turn then reset the gap. The shank portion forward of the threads is already thin so it's going to look a little "off".
- Status
-
Not open for further replies.