Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bearing Question

Discussion in 'Gunsmithing and Repairs' started by LubeckTech, Nov 16, 2007.

Thread Status:
Not open for further replies.
  1. LubeckTech

    LubeckTech Member

    Joined:
    Sep 13, 2006
    Messages:
    871
    Location:
    Parkersburg, WV
    Does anyone know the I.D. and O.D. dimensions for S&W K frame end shake bearings? I've got my yoke anc cylinder prepped and may have a local source of the bearings. I don't mind getting them from Midway it's just the shipping cost that bugs me.
     
  2. Jim K

    Jim K Member

    Joined:
    Dec 31, 2002
    Messages:
    17,752
    The OD is less than the ID of the cylinder and the ID is the same as the ID of the crane arbor. Anyone selling those shims should have them right; if not, are you sure you are getting the right thing or something someone ginned up?

    Also you really have to square up the arbor with a special tool before installing the shim(s).

    Jim
     
Thread Status:
Not open for further replies.

Share This Page