Rollis R. Karvellis
Member
Good Morning, later today I will be bedding my new MVP. The accuracy, and precision just does not exist with this rifle. It makes a SKS look like an Accuracy International.
I plan to bed the portion of the receiver behind the trigger, and the front of the receiver, barrel lug, and barrel nut, my question is should I also bed the exterior of the plastic magazine housing, and if so should I also bed the top of the housing where the receiver lays?
The stock is pillar bedded, but there is a good bit of flex between the action, and the stock. Also the screws will not keep the 50 inch pound setting I have been trying to maintain with it.
Anyone else have this dilemma with the MVP, and if so what did you do?
Once I get to the plant to load, I will try to upload photos of the disassembled parts.
Thanks.
I plan to bed the portion of the receiver behind the trigger, and the front of the receiver, barrel lug, and barrel nut, my question is should I also bed the exterior of the plastic magazine housing, and if so should I also bed the top of the housing where the receiver lays?
The stock is pillar bedded, but there is a good bit of flex between the action, and the stock. Also the screws will not keep the 50 inch pound setting I have been trying to maintain with it.
Anyone else have this dilemma with the MVP, and if so what did you do?
Once I get to the plant to load, I will try to upload photos of the disassembled parts.
Thanks.