Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Benelli front sight post

Discussion in 'Shotguns' started by Slimjim, May 25, 2005.

Thread Status:
Not open for further replies.
  1. Slimjim

    Slimjim Member

    Joined:
    Jan 3, 2004
    Messages:
    751
    Location:
    Maryland.
    Does anyone know what size the nut is on the front site post on the benelli m1 super 90. Mine is slightly off and i cant seem to find one small enough to fit it in my box, but i may need a whole new set of micro wrenches, is it metric or standard, does anyone know what size i need or someway to get it loose to reposisiton and tighten it?
     
  2. DougW

    DougW Member

    Joined:
    Mar 16, 2004
    Messages:
    2,057
    Location:
    North Texas
    Had the same problem. Couldn't get the info, so I called a friend that has a M1 Super 90. He used needle nose plyers. I figured, what the hell, and did the same thing. I guess you could take the barrel to a hardware store and see if someone can help you fit an open end wrench to it. I boight the smallest crescent wrench I could find, and it was too big to fit in the slot. Good luck.
     
  3. Slimjim

    Slimjim Member

    Joined:
    Jan 3, 2004
    Messages:
    751
    Location:
    Maryland.
    Its a 15/64th inch wrench. You need a set of ignition wrenches to get the right one.
     
Thread Status:
Not open for further replies.

Share This Page