Brass to 300blk.. Chamfer tool for after cut (I have a Giraud tri-way but..)

[taymag]

Whats a decent chamfer and deburring tool to use for a quick pass after the shoulder cut? My tri-way is perfect for trimming/chamfer/deburring but I need something to chamfer and deburring before sizing.

All I have is that dome Lee handheld chamfer and deburring tool... Anything better for a couple hundred cases or should I just stick with that?

 

[gotboostvr]

I got one of the Lyman "pen" style because I was tired of using the little Lee numb style chamfer and deburring tool.

 

[Blue68f100]

I think all of mine are RCBS but they all work the same. Just pick one and go.

 

[Paddy]

I was thinking about using a wire brush on the pedestal grinder for this. Another option is to throw them in the tumbler for a while.

 

[Walkalong]

I was thinking about using a wire brush on the pedestal grinder

Yikes!

I still use an old RCBS chamber/deburr tool. The Wilson is cheaper at Midway. Any of this type will serve you well.

 

[dh1633pm]

I have a three station powered model from Hornady. Makes short work of the problem after cutting with my mini saw. Can't beat it with a stick. There are other brands, but a power tool cuts down on the time spent big time.

http://www.amazon.com/Hornady-Lock-Load-Case-Prep/dp/B007TNXAGM

The tool shown above in the link, I have mounted on a 2x4 to make it higher off the bench. Too low for my taste without something to raise it up. The tool heads are too close to the bench.

 

[Paddy]

I have the same Hornady tool and I like it, but I recently hot rodded it by using an 18v wall wart and ditched the 12v. Much faster! Hasn't seemed to kill it yet, I may even try 24v.

 

[farmerboy78]

Hornady case trio