VrockTDSaz
Member
I'm decapping crimped primers with my lee 9mm sizing die. Or at least I was until I snapped the rod. The center of the primer is getting punched out leaving the primer rim wedged in the primer pocket.
Will a Lee universal decapping die solve this or is the pin the same as in my 9mm die?
The rim is harder than the surrounding brass pocket, making it difficult if not impossible to swag. With the primer rim jammed in the primer pocket it won't prime.
Edit: The photo shows a case with primer rim still stuck, a primer rim I managed to mangle another case and get it out, and the center that gets punched out.
Will a Lee universal decapping die solve this or is the pin the same as in my 9mm die?
The rim is harder than the surrounding brass pocket, making it difficult if not impossible to swag. With the primer rim jammed in the primer pocket it won't prime.
Edit: The photo shows a case with primer rim still stuck, a primer rim I managed to mangle another case and get it out, and the center that gets punched out.