offthepaper
Member
- Joined
- Dec 5, 2005
- Messages
- 1,446
I'm just getting into reloading.
I started loading last month for my K31, 7.5x55.
When I went to seat a 150gr FMJBT into some once fired Privi brass, the bullet seemed to go into the neck with little resistance. After repeating this several times I realized that a couple of the bullets were actually loose in the necks.
I'm thinkingI had the decap/sizing die turned too far into the press when I was removing the primers.
Any thoughts or suggestions?
Also, is there anything I can do for the now over expanded necks on several pieces of brass to make them usable again?
I started loading last month for my K31, 7.5x55.
When I went to seat a 150gr FMJBT into some once fired Privi brass, the bullet seemed to go into the neck with little resistance. After repeating this several times I realized that a couple of the bullets were actually loose in the necks.
I'm thinkingI had the decap/sizing die turned too far into the press when I was removing the primers.
Any thoughts or suggestions?
Also, is there anything I can do for the now over expanded necks on several pieces of brass to make them usable again?