coachman48
Member
- Joined
- Feb 7, 2008
- Messages
- 54
Hey
I finally got my reloading equipment,bench setup. I am using RCBS dies and Rockchucker press. I am loading 40S&W with Remington 155JHP. I have the oal at 1.135 - 1.129 and when I push on the bullet after they are crimped against the bench by hand it does not move back into the case any, but when I dry cycle thru my gun they get shorter. The aol will be 1.31 -1.124. Is this normal or do I need more crimp. I am trying to get my dies set up. I do not have not put any primers or powder in the bullets yet. Dumby loads
Thanks
Bob
I finally got my reloading equipment,bench setup. I am using RCBS dies and Rockchucker press. I am loading 40S&W with Remington 155JHP. I have the oal at 1.135 - 1.129 and when I push on the bullet after they are crimped against the bench by hand it does not move back into the case any, but when I dry cycle thru my gun they get shorter. The aol will be 1.31 -1.124. Is this normal or do I need more crimp. I am trying to get my dies set up. I do not have not put any primers or powder in the bullets yet. Dumby loads
Thanks
Bob