Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

can some please help me put my ruger p90 back together??

Discussion in 'Handguns: Autoloaders' started by emagdnim, Feb 1, 2010.

Thread Status:
Not open for further replies.
  1. emagdnim

    emagdnim Member

    Joined:
    Feb 1, 2010
    Messages:
    1
    I stripped my ruger p 90 to clean it than when I was putting it back together two pins located on the back of the frame camout along with a small srping and two small metal objects. I know both these small metal objects are held in by the two pins that came out. One of the metal objects holds the small spring in the back close to the hammer. I just don't know how exactly they go back in. Please help me. Any input would be greatly appreciated.
     
  2. Mike J

    Mike J Member

    Joined:
    Jul 3, 2007
    Messages:
    2,178
    Location:
    Georgia
    You might want to try www.rugerforum.com if you don't get an answer here. There is a lot of info on P-series rugers there.
     
  3. gb6491

    gb6491 Member

    Joined:
    Apr 17, 2006
    Messages:
    1,707
    Location:
    Yuma County, Arizona
Thread Status:
Not open for further replies.

Share This Page