once you size the brass and cut to lenght .........the neck has burrs on the inside and outside.........i have the ch4d deburring tool.......to process alot of brass takes a long time by hand......im wondering if anyone know a quicker way to clean the necks ........is there a machine i can buy? thanks !!!!!!!!!!!!!!
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
case neck deburring/cleaning
- Thread starter poker2112
- Start date
- Status
-
Not open for further replies.
Lone_Gunman
Member
A Giraud case trimmer will cut your brass to length, chamfer, and debur in one easy step. If you have to process a lot of brass, its the way to go. It is a wonderful piece of equipment. I bought one a few months ago, and you can process hundreds of pieces of brass per hour.
Yes there is: http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=565099&t=11082005
The RCBS Trim Mate.
The RCBS Trim Mate.
Big Boomer
Member
try this
http://www.lymanproducts.com/lymanproducts/caseprep.htm
from Lyman, I have one and cuts the time in half at least but more importantly cuts down on your finger blisters and wrist cramps with a manual one. They are the cheapest that I have seen and work good.
RCBS also makes a nice station but is a bit over a hundred dollars the Lyman is about half that.
Scroll down the page on the link to find the Lyman power deburr kit
http://www.lymanproducts.com/lymanproducts/caseprep.htm
from Lyman, I have one and cuts the time in half at least but more importantly cuts down on your finger blisters and wrist cramps with a manual one. They are the cheapest that I have seen and work good.
RCBS also makes a nice station but is a bit over a hundred dollars the Lyman is about half that.
Scroll down the page on the link to find the Lyman power deburr kit
- Status
-
Not open for further replies.