Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Case trimming question

Discussion in 'Handloading and Reloading' started by KFDiesel, Aug 15, 2010.

Thread Status:
Not open for further replies.
  1. KFDiesel

    KFDiesel Member

    Joined:
    Aug 9, 2007
    Messages:
    53
    Location:
    Indiana
    I trimmed back some 22-250 brass and around the case neck they are "sharp", actually the trimmed brass has kind of a Ridge around it. Should I just use a metal file and do the best I can?
     
  2. Blackrock

    Blackrock Member

    Joined:
    Oct 31, 2009
    Messages:
    521
    Location:
    SE Arizona
    Now you use an inside/outside chamfering tool on the case mouth. Just easy does it to remove the burrs.
     
  3. Sam1911

    Sam1911 Moderator

    Joined:
    Oct 22, 2007
    Messages:
    33,548
    Location:
    Central PA
    This is the kind of deburring tool I use, though there are several designs.

    [​IMG]

    Midway and others carry them for $10-15.
     
  4. loadedround

    loadedround Member

    Joined:
    Feb 18, 2006
    Messages:
    3,343
    Location:
    Valley Forge, Pa
    I've used the same tool used by Sam1911 for years and it does any excellent job. They are made by RCBS and any gun shop selling reloading equipment will have one. About 15.00.
     
Thread Status:
Not open for further replies.

Share This Page