Chopper T
Member
- Joined
- Aug 16, 2019
- Messages
- 4
I've recently began reloading rifle cartridges. Up until this point I have not needed to trim cases as I have only reloaded straight walled revolver rounds. Anyway, I'm new to case trimming and I have a really simple question. Is there any reason that I should not simply use a "template case" trimmed to the recommended trim case length to set my Trim Pro 2 and then leave it there and run the rest of my resized cases through it? I am reloading for my Winchester Model 94 .30 .30.
Thanks
Thanks