CG Haenel Suhl Schmeissers schematic

[bnormal2]

I am looking for a schematic and dissassembly instructions for a CG Haenel Suhl Schmeisser's Patent pistol. Seems that my gunsmith can't figure out how to get it apart for refinishing. Any help is greatly appreciated.

 

[Roadkill]

Good question. I've had one an Uncle brought back from WWII for about thirty years, can't figure how to take it apart either. Good shooter though.


rk

 

[BEARMAN]

A schematic is available at ( www.again.net/~steve/page7a.htm ) There ia also a GERMAN SITE with photos and some english text. at ( www.vestpockets.bauli.at/ ) From looking at the diagram my GUESS is pull the slide back to clear the rails on the end of barrel then pull the recoil spring guide away from the frame to free barrel, lift barrel straight up and ease slide forward off frame . I do not have one of these firearms and am only going by the diagram, study it yourself before trying to disassemble. GOOD LUCK

 

[bnormal2]

directions for break down

it´s indeed a litle bit tricky:

- pull back the slide and fix it in the rear position with the safety lever.
- Pull out the mainspring rod against the tension of the spring and release with an angle to the former alignment, so it won´t go in again
- pull out the barrel block to the TOP
The notch at the bottom of the clip will fit into the groove on the front of the mainspring rod to pull it out (at least, if you got a genuine clip)
Note, that there is an interlocking between the release of the clip and the safety lever.

greetings from Austria
Gerhard