ZBill
Member
- Joined
- Sep 12, 2004
- Messages
- 397
Can anyone provide/describe the process of removing the ejector assembly for a Charter Arms 1st generation Bulldog .44 Spl revolver? The gun fuctions fine except for the ejector rod assembly. It is feels "gritty" when pushed in to push out the empties and fails to retract unless I apply pressure to the rear of the assembly star. I liberally applied Gunscrubber and see no improvement.
Note sure if the spring is broken or there is a burr that I can remove. The rod does not appear to the bent whatsover.
Thank you for your time. Bill
Note sure if the spring is broken or there is a burr that I can remove. The rod does not appear to the bent whatsover.
Thank you for your time. Bill
Last edited: