• You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.

Citori choke question

Status
Not open for further replies.
M

mrpabst1

Member
Joined
Sep 7, 2007
Messages
10
I been looking at a used Citori 12 gauge that has fully choked barrels,Its chambered for 3 inch shells ,can I shot steel through it and is it possible to have it tapped for a invector choke system.The guns really clean and tight and priced right.Thanks
 
Most manufacturers don't recommend shooting steel shot through full chokes. Modified provides a good pattern with steel without damaging your chokes.

Invector II's are a little pricey... (I have a newer Citori with Duratouch, 3 1/2 chambers and screw in Invector II's -- and just absolutely love the gun). But if you're going to have it tapped for screw-ins, see what the gunsmith recommends. If you don't have a problem with having a non-Browning choke screwed in to it, they may prefer to tap for Winchester/Mossberg thread pattern -- and those chokes run a little less $ as a rule.

I'd check with a competent gunsmith and see what they recommend.
Good luck and congrats for owning a very nice O/U.
 
Status
Not open for further replies.
Back
Top