halfmoonclip
Member
- Joined
- Feb 4, 2011
- Messages
- 2,790
My 986 came back from Springfield with a new ratchet, but, unfortunately, zero clearance between the cylinder face and the forcing cone. I've already taken a little off the forcing cone, and the gun is back to functioning.
But it is still a tight clearance; I'm figuring on a little more careful work with a file and stone.
I've found a quote of 0.006" clearance; is this the recommended dimension?
Thanks in advance,
Moon
But it is still a tight clearance; I'm figuring on a little more careful work with a file and stone.
I've found a quote of 0.006" clearance; is this the recommended dimension?
Thanks in advance,
Moon