CZ 75 Night Sights ??

[viking499]

Who makes night sights to go on the CZ 75 and compacts?

 

[kentucky_smith]

I'm curious as well. Be nice to find just a front sight to pin on.

 

[The Lone Haranguer]

http://www.midwayusa.com/viewProduct/?productNumber=212632

Angus at http://czcustom.com can drill the existing sights and install inserts in them. I suspect this might be a little pricey, however. You should only need to ship the slide, which can be done by mail.

 

[StorkPatrol]

85 bucks is a good price for Meprolights. You guys wouldn't happen to know what tools are required...would you? --Stork

 

[viking499]

If it's like most things, it takes a really big hammer. And maybe some vise grips and Duct tape...

85 isn't bad. Might need to check into that. Need a few things from Midway anyway.......

Anybody else make them for the CZ?

 

[CZF]

I've used the front sight pin to secure new tritium front sights on my CZs before.

The rear sights are the tough part.

CZ-USA used PT-NITES for a long time, but have been with the
Meprolight Tru-Dots in the past couple of years now.

These went onto my Custom SS :



My wifes new PCR:


They actually want you to send in the entire pistol.



My P-01/RAMI:


As you can see. I'm a big fan of Nites and Laser Grips!

 

[viking499]

CZF,

Did the meprolights fit on both the PCR and P01 without any problems?

 

[CZF]

CZ-USA put them on for me.

They did a good job as the sights are dead on.

 

[ClickClickD'oh]

I have Trijicon green/yellow on most of my CZs.

 

[viking499]

Does anyone sell just the front sight?

 

[bob7398]

cz custom shop sells just the front sight....
i just put one on my P01.
http://czcustom.com/cz-factory-sights.aspx

 

[Gary G23]

I've put Meprolights on quite a few CZ's. I used a sight pusher on the rear. On the front you have to cut out the area on the bottom of the sight where the pin goes through. The tough part is doing this correctly. Take your time, measure things up, and remove a little material at a time.

 

[BullsAndClays]

I bought a set of the 'removed' SP-01 sights from Angus at CZCustoms and pressed them into my P-01 with no problem.