mikemyers
Member
A relative of mine owns a "CZ Model 512". He needs a special tool, which no longer seems to be available.
The 'pdf' version of the manual can be found here:
http://cz-usa.com/hammer/wp-content/uploads/2014/04/Instruction-Manual-CZ-512_en.pdf
The relevant paragraph is:
"Note: During the assembly of the recoil springs use the guide fork (it is supplied only with the bolt of caliber .22LR) which ensures an
accurate and simple lead of the springs into the holes in the bolt (Fig. 9)."
Figure 9 shows this:
Any suggestions on where to buy one of these tools would be welcome.
The 'pdf' version of the manual can be found here:
http://cz-usa.com/hammer/wp-content/uploads/2014/04/Instruction-Manual-CZ-512_en.pdf
The relevant paragraph is:
"Note: During the assembly of the recoil springs use the guide fork (it is supplied only with the bolt of caliber .22LR) which ensures an
accurate and simple lead of the springs into the holes in the bolt (Fig. 9)."
Figure 9 shows this:
Any suggestions on where to buy one of these tools would be welcome.