ultralightbackpacker
Member
- Joined
- Sep 14, 2007
- Messages
- 129
OK, so I finally tweaked a dillon 1" wrench, and decided to buy a craftsman 1" combo wrench. So I removed the toolhead with 38 spec plates, and replaced with my 9mm. Low and behold the 1" wrench doesn't fit the lock rings on this toolhead/lock rings 9mm dies. They are larger (I have not reloaded 9mm in ages). :banghead:
OK, so question what is the standard outside diameter lock rings that dillon uses? I used to have a bunch of RCBS dies, perhaps these are from the RCBS dies or maybe dillon changed?
Anyway, I kind of like the larger rings, they measure about 1.14" outside diameter.
OK, so question what is the standard outside diameter lock rings that dillon uses? I used to have a bunch of RCBS dies, perhaps these are from the RCBS dies or maybe dillon changed?
Anyway, I kind of like the larger rings, they measure about 1.14" outside diameter.