If so, how hard is it to turn the elevation knob? I recently got one, and the elevation knob is very difficult to turn. Much harder than on an AR. There is a threaded hex head screw on the top of the site and if i loosen it some, I can adjust the elevation knob, but it is still difficult.
Is this normal?
Also, I have disassembled the sight and put it back together. It now seems to work a little better, but not much. There is a small ball bearing on the fits between the bottom of the elevation knob and the lower reciever. There are two small indents on the lower receiver. Does the ball bearing fit into the indent that has the spring in it? or in the other one?
Is this normal?
Also, I have disassembled the sight and put it back together. It now seems to work a little better, but not much. There is a small ball bearing on the fits between the bottom of the elevation knob and the lower reciever. There are two small indents on the lower receiver. Does the ball bearing fit into the indent that has the spring in it? or in the other one?