I’m building an AR-10 from a DPMS L308 lower. The rear takedown spring and detent is kicking my butt!!
This lower doesn’t have the hole behind the retaining plate for the buffer tube. Instead, it has a hole on the inside of the right-hand hole for the pin itself. You have to insert the spring and (somehow) the detent, then slide the takedown pin in. The photo shows the spring in place.
I’ve tried everything I can think of, but it’s a crazy-tight space to work in. Is there some DPMS trick that I’m missing to make this work?
Thanks!!
This lower doesn’t have the hole behind the retaining plate for the buffer tube. Instead, it has a hole on the inside of the right-hand hole for the pin itself. You have to insert the spring and (somehow) the detent, then slide the takedown pin in. The photo shows the spring in place.
I’ve tried everything I can think of, but it’s a crazy-tight space to work in. Is there some DPMS trick that I’m missing to make this work?
Thanks!!