sauer1911
Member
Ahh the blue koolaid is great!
I am hooked! There is a little learning curve to be had.
Mainly because I just jumped in and didnt finish reading all the instructions.
Do not cut the spring under the big ball bearing that indexes the brass thru the machine. Some people suggest this to stop powder slinging around, just tighten the center bolt to get rid of the vertical movement, and there is a little bent arm that guides and keeps the brass directly over the primer installation. It should be adjusted to about a business cards thickness of play from the brass.
That way you wont have primers going BOOM! like I did, hehe. whew
After all that I was making some progress! constantly watching the powder level before adding the bullet and now i am out of 9mm brass, and have quite the inventory of 9mm ammo!
Blue tastes good.
be safe
I am hooked! There is a little learning curve to be had.
Mainly because I just jumped in and didnt finish reading all the instructions.
Do not cut the spring under the big ball bearing that indexes the brass thru the machine. Some people suggest this to stop powder slinging around, just tighten the center bolt to get rid of the vertical movement, and there is a little bent arm that guides and keeps the brass directly over the primer installation. It should be adjusted to about a business cards thickness of play from the brass.
That way you wont have primers going BOOM! like I did, hehe. whew
After all that I was making some progress! constantly watching the powder level before adding the bullet and now i am out of 9mm brass, and have quite the inventory of 9mm ammo!
Blue tastes good.
be safe
