Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Finally found an IWB holster for my 3" GP-100

Discussion in 'Handguns: Holsters and Accessories' started by bigmike45, Sep 14, 2009.

Thread Status:
Not open for further replies.
  1. bigmike45

    bigmike45 Member

    Joined:
    Aug 12, 2004
    Messages:
    1,021
    Location:
    Texas
    I picked up a stainless factory DAO 3" GP-100 about a year ago and have been looking for a good IWB holster for it since. I prefer holsters with the attachments fore & aft the actual area holding the gun. It wraps around my body much better and conceals much better. I have talked to several of the custom holster manufacturers I have done business with in years past but none had a 3" gun form. Revolver barrel lengths are usually even numbered and I did not want the barrel to stick out the bottom, or have an extra inch of unused leather either.....yeah I am kinda picky that way. I came across a fellow in one of the forums selling a Tucker Gunleather Texas Heritage IWB holster. It was like new and for a 3" L-Frame Smith & Wesson. It came in today and my Ruger slid right into the holster like it was made specifically for my gun. I am one happy camper as I am very familiar with Mr Tucker's fine holsters...and this one makes #7 for me. Here are a few pictures.

    [​IMG]
    [​IMG]
     
  2. edw794

    edw794 Member

    Joined:
    Dec 28, 2002
    Messages:
    26
    Location:
    subduction zone
    nice looking gun. i had a tucker for a smith K frame and i found the cylinder would bind against my belt when the gun was adjusted with a forward rake. i had to carry the gun with a backward rake in order to draw it. other than that, it was a very well constructed holster.

    ed
     
Thread Status:
Not open for further replies.

Share This Page