cleanview
Member
Well I took some more test rounds to the range this after noon. I had successfully loaded missouri bullets for my 9mm cz 75b earlier. They were 147 gr bullets. So I made samo varying loads for the 125 gr that I had ordered as well. When I racked the gun to chamber a round, it chambered without closing all the way and would not open. I took it apart and had to pry the bullet out. It would get stuck about 1/16 of an inch before going in all the way. I compared how other rounds lay in the barrel and the new loads would not go in all the way. I came home and measured the diamater where the brass ends and bullet starts and it was the same as other rounds and then the bullet of course was the same measurement and the oal is the 1.121 whic is shorter than the others which are 1.130.
I know I am new but I cant wrap my head around why the bullet is the same measurements wont go in like the others.
Any help?
I know I am new but I cant wrap my head around why the bullet is the same measurements wont go in like the others.
Any help?