First outing with Henry BB X in 45 Colt

[Rob96]

This past Friday I was able to get up to the range to test this rifle out with a factory load and a few loads I made. Rifle is topped with a Sig Romeo 5 and is for the purpose of close in brush/woods hunting. Started at 25yds to get tings set, then moved to 100yds. Gog conditions kinda made it hard but all went well.

Corbon 300gr JSP "+P"- you know it's something special when you touch one of these off. Nice 1" groups.
250gr Lasercast RNFP with 9grs of Unique. Accurate load again a 1" performer
255gr Missouri SWC Hi-Tek coated:

1. 9grs of True Blue: shot extremely low but tight at 100yds. Going to bump this up to 12.1 to see how it goes
2. 9grs of Unique: Great load

250gr Hornady XTP with 10.3grs of Unique: Very performer. I do have H110 for this bullet but till need to find magnum pistol primers.

All in all this rifle will be great for its intended purpose. Targets used were 2" orange dots on cardboard so at 100yds the red dot covered the entire red dot.

 

[kidneyboy]

My older BB shoots about the same using Acme 250gr RNFP, although I settled on 8.5gr of Unique. I use a Ranger Point Precision peep sight.

 

[Jonny2guns]

Come on man, you know the rules....pics of the rifle, targets, and ammo or it didn't happen. Sounds like a good time anyways.

 

[Rob96]

Come on man, you know the rules....pics of the rifle, targets, and ammo or it didn't happen. Sounds like a good time anyways.

LOL.......I will try to get pics of the gun and the ammo when I load some more today or tomorrow.