gravelyctry
Member
A buddy of mine gave me about 70 rounds of once fired brass for a Rem 700 rifle in 300 Win Mag that I bought from him.
I had already loaded up about 100 pieces of new Winchester brass, and another 50 in Remington brass, after trimming each of them to the same length. I went to trim the brass he gave me, and it was short - almost .015 inches less than the Hornady reloading manual gives as a trim length.
Will the short length hurt anything? It's all Frontier brass, so I'd welcome any opinions on the quality of brass. Who actually makes it? I heard that Frontier brass was made by Hornady, but I'm not sure if that's true or not?
Thanks, Neil
I had already loaded up about 100 pieces of new Winchester brass, and another 50 in Remington brass, after trimming each of them to the same length. I went to trim the brass he gave me, and it was short - almost .015 inches less than the Hornady reloading manual gives as a trim length.
Will the short length hurt anything? It's all Frontier brass, so I'd welcome any opinions on the quality of brass. Who actually makes it? I heard that Frontier brass was made by Hornady, but I'm not sure if that's true or not?
Thanks, Neil