Coltdriver
Member
If you form and tweak any AI brass I would sure appreciate your comments.
I got some 243 Lapua brass, formed it with a blank charge, reamed the necks, then loaded up some 87 grain Noslers and got outstanding results.
When the brass formed there is a little donut around the neck right at the shoulder to neck junction.
Do you trim this off with a neck trimmer??
How close to the neck shoulder junction do you trim to?
Thanks!
I got some 243 Lapua brass, formed it with a blank charge, reamed the necks, then loaded up some 87 grain Noslers and got outstanding results.
When the brass formed there is a little donut around the neck right at the shoulder to neck junction.
Do you trim this off with a neck trimmer??
How close to the neck shoulder junction do you trim to?
Thanks!