Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Glock issues

Discussion in 'Handguns: Autoloaders' started by Slater, Nov 29, 2007.

Thread Status:
Not open for further replies.
  1. Slater

    Slater Member

    Joined:
    Jun 20, 2003
    Messages:
    1,140
    Location:
    Flagstaff AZ
  2. triguy

    triguy Member

    Joined:
    Apr 24, 2007
    Messages:
    56
    Location:
    Northeast
    Slater,
    I've seen it twice. The main portion of your extractor sheared from it's post that is held in the slide by the firing pin saftey. Once that fell out it allowed the plunger to travel a bit to far. Disassemble and push the pin saftey and the broken post should drop out. Replace the extractor, install your plunger assembly and end cover. Put the slide back on the frame and cycle a few times to check function and shoot. triguy
     
Thread Status:
Not open for further replies.

Share This Page