Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Glock mods

Discussion in 'Handguns: Autoloaders' started by cajuncracker, Feb 22, 2011.

Thread Status:
Not open for further replies.
  1. cajuncracker

    cajuncracker Member

    Joined:
    Feb 22, 2011
    Messages:
    1
    I recently purchased a new G17 gen 3 with extended slide release. Can anyone tell me pros and cons about Glockworx competition spring kit, and 2lb. race connector that I just ordered?
     
  2. iblong

    iblong Member

    Joined:
    Jan 22, 2009
    Messages:
    505
    Location:
    Minnesota
    Is this going to be a carry pistol?
     
  3. REAPER4206969

    REAPER4206969 Member

    Joined:
    Jun 7, 2004
    Messages:
    3,037
    Location:
    Idaho
    Competition springs should not be used in serious use pistols due to the high probability of malfunctions, most notably Failures To Fire.
     
  4. mbruce

    mbruce Member

    Joined:
    Nov 24, 2010
    Messages:
    399
    Location:
    Western NC
    maybe have asked that question before you ordered....:)

    None the less -- I've only known people to order the Ghost Trigger Bar and Wolff springs.

    I have found when I start playing with lighter springs the trigger does not reset far enough to enact the trigger safety. To me the trigger safety is more important than that light of a trigger. hopefully the change won't negate your trigger safety -- if it does I highly advise to reconsider...
     
  5. iblong

    iblong Member

    Joined:
    Jan 22, 2009
    Messages:
    505
    Location:
    Minnesota
    If its for carry the most Id do is a 3.5 connector and a over travel stop leaving all springs in stock configeration.Safer and still reliable.
     
Thread Status:
Not open for further replies.

Share This Page