Fatelvis
Member
What is a good "middle of the road" power load for the 10mm, using a 180 grn jhp bullet? Thanks-
Good mid-powder 180 grn 10mm load
- Thread starter Fatelvis
- Start date
- Status
Glock20
Member
Fatelvis - I've had good accuracy with 180gr JHP mid 10mm auto loads using -
Hodgdon's (online) data of 6.0 grains of TiteGroup & 6.4 grains of Universal. Both are max for the powder listed on the site, but are mid + loads for a 10mm at a little over 1100 fps.
You should start at the lower end of Hodgdon's data and work up.
I've used Montana Gold's 180gr JHP and Hornady's XTP's with these loads and they are both very accurate out of my Glock 20.
Hodgdon's (online) data of 6.0 grains of TiteGroup & 6.4 grains of Universal. Both are max for the powder listed on the site, but are mid + loads for a 10mm at a little over 1100 fps.
You should start at the lower end of Hodgdon's data and work up.
I've used Montana Gold's 180gr JHP and Hornady's XTP's with these loads and they are both very accurate out of my Glock 20.
- Status
