Grips for S&W CS9

[4eyes]

Hello High Roaders.
I have two semiautos that daughters will probably get but they both want the same gun. I have 3913 TSW and CS9 stainless and alloy. They like slim grips on 3913 and hate fat Hogue grips on CS9. Is there a slim grip available from Smith and Wesson or other source that will replace that Hogue grip on the CS9? I was reading about a model 908 somewhere and was hoping that may be an option for me. Thanks for any info you can provide.

 

[muzzleblast...]

Check out the Smith and Wesson Forum. Looks like a guy there is starting to make aluminum CNC grips for the CS series.

 

[4eyes]

well I actually found a set of grips on somebodys table at the gunshow. They were for a single stack s&w auto. They were a little too long but I cut em down an eighth inch and sanded them till they were an exact fit lengthwise. Using vernier calipers I located the screw hole and drilled the grips for screws. The project was complete . Total cost 12 bucks. Thanks for your help.